Put Me Back

DeviceSimplePack 1.4 and newer or SimplePack Plus
ManufacturerSimpleHW
Use casesImagine anything leaning or turning or displaced.
It measures min and max positions while moving. When movement stops (device is steady for defined time) a message is sent with current orientation data. Garbage bins, road signs, electricity poles.

If a movement is detected a measurement starts.Sensitivity can be adjusted. The measurement continues until stillness for a time period set in Arrival delay is achieved. A message with min, max and final values of device orientation related to ground (Earth gravity) is sent and downlink can be requested. The device stops reacting for Sleep time interval. If a movement is detected a measurement starts again.

Recommended subscription planSILVER+ (50 uplinks/1 downlink) will be sufficient in most cases. If you need changing device setup more frequently or send more messages, we recommend more flexible subscription plan like GOLD+ or PLATINUM+.

Limits on number of messages are checked against monthly average.

Specific settingsFor this device mode, you can set:

  • On/off LED diode (for energy savings)
  • Force/keep operational status (arm/disarm)
  • Remote device update on heartbeat
  • Heartbeat period [hours]
  • Message departure delay [seconds] – time after arming, when movement is not detected. This lets you finish manipulation after arming device by button press.
  • Movement sensitivity
  • Sleep time [minutes] after the message has been sent
  • Arrival delay [minutes]. Time from when the device stopped moving. After this time a message is sent to inform you that your device is not moving yet.
ActivationFirst, complete registration of your device at I/O Frog and then activate SimplePack using extra long press (about 10s). LED diode starts rapid blinking. When blinking stops, device is activated and connected to network.

If you change any device parameter in application, this new setup has to be also transferred to device. Application itself cannot force device to download new settings, only the device can initiate it. After updating new parameters, please, update your device by extra long press (about 10s) or via heartbeat forced downlink. Successful loading is confirmed by LED diode for several seconds.

After activation or mode change, arm your device by pressing the button or you can force arming with downlink (using force/keep operational status parameter).

AlertsDevice send these messages via I/O Frog:

  • Arming
  • Orientation changed! (including min, max and last XYZ position vector
  • Device setting confirmed / failed
  • Heartbeat
  • GEO location (in case it is included in your subscription plan)
DeactivationUsing a switch on device dashboard followed by downlink (extra long press (about 10s) or forced by heartbeat).
1
2
3
4
5
1

Waterproof

2

Long-lasting (10 years with daily heartbeat)

3

Reliable

4

Cheap

5

Small

Screenshots and device images